Royal Sovereign RSH-1050 用户手册

If it happens, the speed needs to be lowered by one speed level and started again
after

signal on the LCD window.

3. In case of wrinkling or rolling of film due to wrong position of document, 

is needed to be keeping pushed in order that document could come out 

to the front with buzzer sound.

4. When document is much smaller than film, you should place it in the middle of film
    for preventing wrinkle
5. Use cooling fan when you laminate continuously without break and 
    document is too hot.

The above laminating speed numbers are at the condition on regular voltage with
 almost no film tension.  There might be the possibility for difference to the
 above numbers due to the change of voltage or adjustment of tension.

1. Put cold roll film on upper bar.(Set the same as  methord of HOT film for
    protect paper of lower part)
2. Pull COLD film, and fix it so that backside protecting paper can be wound on
   take-up mandrel clockwise. (Revolve core to make protectingpaper tight a little bit.)
3. Set pressure lever at the proper position following to your lamination condition.

600mm(2ft)

800mm(2.6ft)

9

2000mm(6.6ft)

4000mm(13.1ft)

3600mm(11.8ft)

8

1800mm(5.9ft)

2000mm(6.56ft)

2400mm(7.9ft)
2800mm(9.2ft)

3200mm(10.5ft)

1000mm(3.3ft)
1200mm(3.9ft)
1400mm(4.6ft)
1600mm(5.2ft)

5
6
7

1
2
3

***Laminating Speed at each level〔mm(ft)/min〕***

4

800mm(2.6ft)

1200mm(3.9ft)
1600mm(5.2ft)

400mm(1.3ft)

REV

 

- 21 -