Royal Sovereign RSC-1400C 用户手册

10

9

9

Loading films to upper and lower film shafts:
(See page 5 for assistance with parts identification.)

1. Adjust the auto grip to fit to the film and tighten the

auto grip screw (Figure 1).

2. Remove the upper and lower film shafts from the

machine and load the films (Center the upper and
lower films on the shaft).  Note the direction of the
adhesives on the lower and upper films 
(Figure  2). 

3. Load the upper and lower film shafts on the

machine (Figure  3). 

Figure 1

Figure 2

Figure 3

Figure 1

Figure 2

Figure 3

The cross cutter is located 

on

 the rear exit table of the 

machine.

1. After lamination, move the cutter approximately to

the center of the completed application at the
desired point of detachment (Figure 1).  

2. Grasp film with one hand, press the cutter

downward into the application and slide it 

from

 

one end 

to

 the other

. (Figure 2 & 3).