SEAL 600-C 用户手册
26
C L E A N I N G / M A I N T A I N I N G Y O U R L A M I N A T O R
CLEANING THE LAMINATOR
•
The laminator may be cleaned with a lint-free cloth,
lightly dampened with a mild soap and water
lightly dampened with a mild soap and water
solution. Do not use spray-on cleaners. Do not
immerse any part of the laminator in water or other
immerse any part of the laminator in water or other
liquids.
•
Do not use an abrasive cleaner, which can damage
the painted surfaces.
•
Do not allow water or liquids to enter the electrical
circuits, which may cause personal injury and/or
circuits, which may cause personal injury and/or
damage the equipment when power is applied.
WARNING! Turn the door interlock to the
OFF Position and then disconnect the
OFF Position and then disconnect the
laminator from the power supply before
cleaning or greasing the bearings.
cleaning or greasing the bearings.
GREASING THE BEARINGS
•
You must grease the top and bottom roller bearings
once each month or every 200 hours. Refer to the
Grease Gun Kit included in your accessory kit for
once each month or every 200 hours. Refer to the
Grease Gun Kit included in your accessory kit for
supplies and instructions.
WARNING! Failure to lube bearings will cause
WARNING! Failure to lube bearings will cause
premature wear, which may cause costly repairs
and will void your warranty.
and will void your warranty.
Call Technical Service for further assistance (see
rear cover).
CLEANING THE ROLLERS
IMPORTANT! Clean the laminating rollers
every day to prevent adhesive build-up and to
every day to prevent adhesive build-up and to
ensure quality output. Adhesive build up may
eventually damage the rollers.
eventually damage the rollers.
•
When laminating, a small amount of adhesive will
squeeze out between the laminate films and onto
squeeze out between the laminate films and onto
the top and bottom rollers. This residue
accumulates through normal use and can be easily
accumulates through normal use and can be easily
cleaned off the rollers.
•
Use the Image roll-cleaner (included) to remove the
excess adhesive from the rollers.
WARNING! Use only an Image Roll Cleaner or
WARNING! Use only an Image Roll Cleaner or
a cotton cloth and Isopropyl Alcohol (IPA) to
clean the rollers. Never pour isopropyl alcohol
clean the rollers. Never pour isopropyl alcohol
(IPA) directly onto the unit. Wear rubber gloves
and use in a well-ventilated area. Do not use
and use in a well-ventilated area. Do not use
other solvents or cleaners. Use of other cleaners
or solvents may cause roller damage and will
or solvents may cause roller damage and will
void the warranty.
•
When cleaning the upper roller, place a piece of
scrap foam board under the roller to prevent the
scrap foam board under the roller to prevent the
removed adhesive remnants from falling onto the
lower roller.
lower roller.