Motorola CPCI-6020 用户手册

Although the CPCI-6020 Single Board Computer can be removed and inserted while power is 
applied, the CPCI-6020-MCPTM-01 transition module is not hot swap capable. Inserting or 
removing the transition module while the CPU board is active may affect the normal operation 
of the CPU board. Even in a hot swap capable chassis, the CPU back end power should be 
switched off (or the chassis power shut down) prior to inserting or removing the corresponding 
transition module.

Follow these steps to remove the transition module from the rear chassis slot.

1. Remove the back-end power from the CPCI-6020 or power down the chassis. 

2. Remove the system or chassis covers.

3. Loosen the screws that attach the transition module to the rear slot.

4. Push the ejector handles outward to the open position; this should disengage the 

connector from the backplane.

5. Using the handles, pull the module from the slot.

The connectors on the CPCI-6020-MCPTM-01 transition module are listed in the next table. 
The port connectors are located on the front panel and the top side of the transition module, 
which is shown in 

. Refer to 

 for a list of the cables and 

 for connector pinout information.

COM3/COM4

J1

50-pin female connector

Ethernet Port 2

J2

Standard RJ-45 female connector

CompactPCI

J3/J4/J5

J3 is a 95-pin AMP Z-pack 2 mm hard metric type B 
connector, J4 is a 110-pin 2 mm hard metric type B connector.

Ethernet Port 1

J6

Standard RJ-45 female connector

Serial Port 1

J7

Standard RJ-45 female connector

Serial Port 2

J8

COM2 9-pin header

EIDE Interface

J9

40-pin header for secondary EIDE port

PIM Connector

J10/J14

Two 64-pin connectors for PMCIO (1 ground provided with 
each PMCIO signal)

Floppy Header

J11

34-pin header for floppy port

SIM Connector

J12/J13

Two 60-pin female connectors for SIMs

Keyboard/ Mouse 
Connector

J15

6-pin circular DIN for combined keyboard/mouse

Serial Port 3

J16

3-pin header for selection of DTE or DCE interface