Epson EL 486UC 用户手册

Follow the steps below to connect the hard disk drive ribbon

cable and a power supply cable to the drive:

1. Locate the free connector on the end of the hard disk drive

ribbon cable.

2. Locate pin 1 on the drive connector. If you do not see it on

the connector casing, turn the drive over so you can see the

drive’s circuit board, as shown below. There is a “1” or “2”

printed on the board to identify the side of the connector

containing pin 1.

3. Position the connector on the cable so that the red wire

aligns with pin 1 on the drive.

4. Make sure the holes in the cable connector fit over all the

pins; then push in the connector.