Epson LT-286e 用户手册

Appendix A

This appendix describes the DIP switches and slide switches you

set to define your system’s configuration. The computer uses this

information each time you turn it on.

If you are using the standard LT-286e settings, that is, you are

using the LCD screen in EGA mode, a parallel printer, and

operating at 12 MHz, you do not need to change the DIP

switches or slide switches.

If you are not using the standard settings, you need to define

your system configuration using these switches. Then return to

Chapter 1 to finish setting up your computer.

The Equity LT-286e has two sets of DIP switches that you access

from the bottom of the computer. These are small, on/off

switches that provide your computer with information each

time you turn it on. A DIP switch is either on (up) or off

(down). To change a setting, use a hard, thin object, such as a

small screwdriver.

The first set has ten switches that control the type of external

monitor you are using and the display configuration. The

second set has ten switches that control the diskette drive, the

CRT/LCD display mode, and the parallel and serial interface

configuration.

Read this section to make sure the current DIP switch settings

match your system configuration.

DIP Switches and Slide Switches

A-l