Renesas M16C/6NK 用户手册

Rev.1.10    Jul 01, 2005    page 153 of 318
REJ09B0124-0110

M16C/6N Group (M16C/6NK, M16C/6NM)

14. Serial I/O

This document is under development and its contents are subject to change.

_______

________ ________

When the CTS function is used transmit operation start when “L” is applied to the CTSi/RTSi (i = 0 to 2)

________ ________

pin.  Transmit operation begins when the CTSi/RTSi pin is held “L”.  If the “L” signal is switched to “H”

during a transmit operation, the operation stops before the next data.

_______

________ ________

When the RTS function is used, the CTSi/RTSi pin outputs on “L” signal when the microcomputer is

ready to receive.  The output level becomes “H” on the first falling edge of the CLKi pin.

•

_______ _______

________ ________

CRD bit in UiC0 register = 1 (disables UART0 CTS/RTS function)  CTSi/RTSi pin is programmable I/O function

•

_______

CRD bit = 0, CRS bit  in UiC0 register= 0 (CTS function is selected)

________ ________

_______

CTSi/RTSi pin is CTS function

•

_______

CRD bit = 0, CRS bit = 1 (RTS function is selected)

________ ________

_______

CTSi/RTSi pin is RTS function

_________ _________

________

_________

This function separates CTS0/RTS0, outputs RTS0 from the P6_0 pin, and accepts as input the CTS0

from the P6_4 pin. To use this function, set the register bits as shown below.

_______ _______

• CRD bit in U0C0 register = 0 (enables UART0 CTS/RTS)

_______

• CRS bit in U0C0 register = 1 (outputs UART0 RTS)

_______ _______

• CRD bit in U1C0 register = 0 (enables UART1 CTS/RTS)

_______

• CRS bit in U1C0 register = 0 (inputs UART1 CTS)

_______

• RCSP bit in UCON register = 1 (inputs CTS0 from the P6_4 pin)

• CLKMD1 bit in UCON register = 0 (CLKS1 not used)

_______ _______

_______ _______

Note that when using the CTS/RTS separate function, UART1 CTS/RTS separate function cannot be used.

_______ _______

Figure 14.22 shows CTS/RTS separate function usage.

Microcomputer

IN

OUT

CTS

RTS

IC

TXD0(P6_3)

RXD0(P6_2)

RTS0(P6_0)

CTS0(P6_4)