Texas Instruments 1 用户手册

   

                                    Troubleshooting Procedures  5-1

This section provides an overview of the fault isolation process, provides guidelines for 
isolating 900 Series computer malfunctions to replaceable subassemblies and provides 
instructions for executing diagnostics and interpreting error messages.

The fault isolation process (summarized in Figure 5-1) consists of the following steps:

♦

Checking the Notebook power system (including battery packs and AC adapter 
connections) - refer to Paragraph 5.4.

♦

Checking Switch settings (ensuring Power is On and notebook correctly 
configured)

- Pressing the Shift key to ensure that Notebook is not in Suspend mode

- Verifying if computer is configured to boot from the A: Drive or C: Drive

- Checking LCD brightness adjustment (press Fn-Up Arrow keys to 

increase brightness)

- Ensuring that computer is not set for external monitor (press Fn-F12 to 

select internal screen)

♦

Undocking from the Mobile Productivity Base (if installed) and running 
diagnostics to isolate problem to either the base or the notebook.

♦

Recording and attempting to resolve any displayed error messages or error 
beeps (refer to Paragraph 5.3.3.1 and Tables 5-1 and 5-2)

♦

Rebooting the system (Ctrl-Alt-Del)

♦

If the computer is capable of running the Setup program; checking the serial 
and parallel port configurations, Sound System enable/disable, and other 
features that may affect system operation.

♦

Running PC-Doctor Diagnostics to further isolate problem area (refer to  
Paragraph 5.5). For indicated hardware failures, cycling power and repeating 
self test to verify that a hard failure has occurred.

♦

Removing and replacing suspect hardware (as described in Section 6 of this 
manual) and retest the system using the diagnostic tests as described in 
Paragraph 5.4.5.