ArtDio IPS 1000 用户手册

                                                                       

      IPS 1000 Series VoIP Gateway

 

 

16

The following table shows an example. 

IP Address 

210.67.96.121 

Subnet Mask 

255.255.255.248 

Default Gateway 

210.67.96.120 

Web Management Password 

123 

 

Using the information contained in the example above. The procedure is as follows: 

   

1.  Connect the IPS unit to a suitable Power source. 

2.  Connect a traditional phone set to the “FXS” connector located on the rear panel. 

3.  When the CPU/ACT light is on, pick up the phone to hear the dialing tone. 

4.  ##0000     

 

 

; you should hear three short tones. 

5. 010#   

 

 

 

; the digit “0” is used to enable “manual” IP mode. 

6. 02210*67*96*121#       ; IP address. 

7. 03255*255*255*248# 

; Subnet Mask. 

8. 04210*67*96*120#       ; Default Gateway. 

9. 15123# 

 

 

 

; “123” is the web management password. 

10. 981# 

    ; 

Warm-restarts. 

11. Hang up the phone. The system should now restart. 

 

You can also use console to configure IP address. But phone number can’t be configured by 

console.(Only 1004/1008/1016) 

SIP-RG>enable 

SIP-RG#configure 

Enter configuration commands, one per line.    End with CNTL/Z 

SIP-RG(config)#ip state user 

SIP-RG(config)#ip address 210.67.96.121 255.255.255.248 

System need to restart 

SIP-RG(config)#ip default-gateway 210.67.96.120 

SIP-RG(config)#exit 

SIP-RG#restart 

This command resets the system.    System will restart operation code agent. 

Reset system, [Y]es or [N]o? Yes