ATTO Technology FC-41EL 用户手册

  

If the devices connected to the Celerity FC host 
adapter are not accessible 

1

Right-click My Computer.

2

Select Properties.

3

Select the Hardware tab. 

4

Select Device Manager.

•  If the Celerity FC host adapter does not appear 

under the SCSI and RAID controllers, remove 
power from the PC, open the case, and check 
that the Celerity FC adapter is properly seated in 
the PCI slot. Replace the case and apply power.

•  If the adapter has been identified but there is an 

exclamation point (!) on the listing, right click on 
the listing and select Uninstall. 

5

Reload the driver (see 

 on page 11).

6

Reboot the system and repeat the installation 
process. 

7

If problems persist, contact your authorized 
ATTO Technology representative.

1

Verify  the  celerityfc driver is loaded with the 

lsmod 

command. If lsmod does not show the 

driver, refer to the installation instructions to 
install and load the driver in 

2

Check the system log with the command 

. The celerityfc driver creates status 

messages during initialization. Make sure that 
all installed cards are properly detected and 
initialized.

3

Examine the contents of the file(s) 
/proc/scsi/celerityfc/X, where X is the 
adapter’s host number. This file contains details 
such as link status, connection speed and 
discovered devices.

Note