Abocom WB2000 用户手册

 

The United States Federal Communication Commission (FCC) 
and the Canadian Department of Communications have 
established certain rules governing the use of electronic 
equipment. 

This device complies with Part 15 of FCC rules. Operation is 
subject to the following two conditions: 
1) This device may not cause harmful interface, and 
2) This device must accept any interface received, including 

interface that may cause undesired operation. This 
equipment has been tested and found to comply with the 
limits for a Class B digital device, pursuant to Part 15 of the 
FCC Rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential 
installation. This equipment generates, uses and can radiate 
radio frequency energy, and if not installed and used in 
accordance with the instructions, may cause harmful 
interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful 
interference to radio or television reception, which can be 
determined by turning off and on, the user is encouraged to 
try to correct the interference by one or more of the 
following measures: 

 

Reorient or relocate the receiving antenna. 

 

Increase the distance between the equipment and receiver. 

 

Connect the equipment into an outlet on a circuit different   

  from that to which the receiver is connected. 

1)  To comply with FCC RF exposure compliance 

requirements, a separation distance of at least 20 cm must 
be maintained between the antenna of this device and all 
persons. 

2)  This transmitter must not be co-located or operating in 

conjunction with any other antenna or transmitter.