Cabletron Systems FOMIM-32 用户手册
Chapter 3: Testing and Troubleshooting
3-4
FOMIM User’s Guide
If failures occur, refer to Section 3.3, Using LANVIEW, in this chapter.
Figure 3-1
Pre-Installation Test
3.3 USING LANVIEW
The FOMIM uses Cabletron Systems built-in visual diagnostic and status
monitoring system called LANVIEW. With LANVIEW, network
troubleshooting personnel can quickly scan LEDs to observe network
status, or diagnose network problems. Figure 1-2 in Chapter 1 shows the
location of the LANVIEW LEDs.
monitoring system called LANVIEW. With LANVIEW, network
troubleshooting personnel can quickly scan LEDs to observe network
status, or diagnose network problems. Figure 1-2 in Chapter 1 shows the
location of the LANVIEW LEDs.
NOTE
A “ping” test will verify that the module is operating properly.
However, both server and client workstations must have their
own unique IP Addresses.
However, both server and client workstations must have their
own unique IP Addresses.
Client Workstation
File Server Workstation
MMAC-M3FNB with IRM3
0494109