Cabletron Systems 9E106-06 用户手册
2-5
Installing the 9E106-06 Module
Figure 2-3. Installing an EPIM
The Reset Switch
The Reset Switch is located on the front panel, under the top plastic tab, as shown
in Figure 2-4. It serves two functions:
in Figure 2-4. It serves two functions:
•
Pressing the Reset Switch twice within three seconds resets the module.
•
Pressing and holding the switch on for three or more seconds causes the
module to shutdown. Pressing and holding the switch again for three seconds
restarts the module.
module to shutdown. Pressing and holding the switch again for three seconds
restarts the module.
SNMP management may be used to disable this switch to enhance module
security.
security.
EPIM
E
N
E
E
T
2
E
N
E
E
T
1
Mounting
Screw