Cabletron Systems HSIM-W6 用户手册
Chapter 7: General Configuration Using Local Management
HSIM-W6 User’s Guide
129
3.
Press ENTER to set the system time.
4.
Use the arrow keys to highlight the SAVE command field at the bottom of the screen and press
ENTER. If the time entered was a valid format, the Event Message field at the top of the screen
displays “SAVED OK”. If the entry was not valid, Local Management does not alter the current
value and refreshes the System Time field with the previous value.
ENTER. If the time entered was a valid format, the Event Message field at the top of the screen
displays “SAVED OK”. If the entry was not valid, Local Management does not alter the current
value and refreshes the System Time field with the previous value.
Setting the Host IP Address
To set the host (the HSIM-W6) IP address, perform the following steps:
1.
Use the arrow keys to highlight the Host IP Address field.
2.
Enter the IP address using Decimal Dotted Notation (DDN) format.
For example: 134.141.25.17
3.
Press ENTER. If the IP address entered was a valid format, the cursor returns to the beginning
of the Host IP Address field. If the entry was not valid, the Event Message field displays
“INVALID IP ADDRESS OR FORMAT ENTERED”. Local Management does not alter the
current value and refreshes the Host IP Address field with the previous value.
of the Host IP Address field. If the entry was not valid, the Event Message field displays
“INVALID IP ADDRESS OR FORMAT ENTERED”. Local Management does not alter the
current value and refreshes the Host IP Address field with the previous value.
4.
Use the arrow keys to highlight the SAVE command field.
5.
Press ENTER. The Event Message field at the top of the screen displays “SAVED OK”.
Setting the Subnet Mask
Subnets are logical divisions of the network. To change the subnet mask from its default value,
perform the following steps:
perform the following steps:
1.
Use the arrow keys to highlight the Subnet Mask field.
NOTE
When entering the time in the system time field, you do not need to add separators
between hours, minutes, and seconds, as long as each entry uses two decimal
numbers. For example, to set the time to 6:45 a.m., type “064500” in the System Time
field.
between hours, minutes, and seconds, as long as each entry uses two decimal
numbers. For example, to set the time to 6:45 a.m., type “064500” in the System Time
field.