Asrock P4I45D+ 用户手册

1 4

2.7 Jumpers Setup

The illustration shows how jumpers are

setup. When the jumper cap is placed on

pins, the jumper is “SHORT”. If no jumper

cap is placed on the pins, the jumper is

“OPEN”. The illustration shows a 3-pin

jumper whose pin1 and pin2 are “SHORT”

when jumper cap is placed on these 2 pins.

J u m p e r

Setting

 PS2_USB_PWR1

Short pin2, pin3 to enable

(see p.8 item 1)

+5VSB (standby) for PS/2 or

USB wake up events.

Note: To select +5VSB, it requires 2 Amp and higher standby current provided by

power supply.

JR1

(see p.8 item 24)

JL1

(see p.8 item 23)

Note: If the jumpers JL1 and JR1 are short, both the front panel and the rear panel

audio connectors can work.

Clear CMOS

CLRCMOS0

(see p.8 item  10)

Note: CLRCMOS0 allows you to clear the data in CMOS. The data in CMOS includes

system setup information such as system password, date, time, and system

setup parameters. To clear and reset the system parameters to default setup,

please turn off the computer and unplug the power cord, then use a jumper

cap to short the pins on CLRCMOS0 for 3 seconds. Please remember to

remove the jumper cap after clearing the CMOS.

2-pin jumper

JR1

JL1