PioneerPOS G24-LC 用户手册
Modem Configuration and Profile
3-202
G24-L AT Commands Reference Manual
April 15, 2008
Two modes exist:
•
Idle mode: The G24-L has no data to send.
•
Wakeup mode: The G24-L has data to send to the terminal.
After the G24-L changes the line edge to Wakeup mode, there will be a delay (the default is 30
ms) sent by the ats102 command before sending any data to the terminal (using RS232 protocol).
ms) sent by the ats102 command before sending any data to the terminal (using RS232 protocol).
Figure 3-11: Sleep Mode when S24 > 0
Figure 3-12: G24-L Lines when S24 > 0
S24, Set Number of Seconds Delay Before G24-L Enters Sleep Mode
This command activates/disables the Sleep mode. The terminal sends ATS24=5, and if there are
no radio and UART activities, the G24-L enters sleep mode in 5 seconds.
no radio and UART activities, the G24-L enters sleep mode in 5 seconds.
If terminal has some indication of the CTS pin activity, it can see:
•
If +MSCTS=0 (default), the line changes its state periodically. (For more information refer to
.)
•
If +MSCTS=1, the line is switched off at the moment of entering Sleep mode and stays off
even if G24-L is awakened.
even if G24-L is awakened.
G 24 C TS
(D efault w hen
(D efault w hen
at+mscts=0)
G24
Slee p mode
(C lock)
Slee p mode
(C lock)
Terminal TXD
Awake
Sleep
S24
Less than S24
WA K EU P-IN
30 ms
S24
30 ms
G24 TXD
WA K EU P-OU T
S102
S102