PioneerPOS G24-LC 用户手册
GPRS
3-236
G24-L AT Commands Reference Manual
April 15, 2008
Example
AT+CGQMIN=?
+CGQMIN: ("IP"),(0-3),(0-4),(0-5),(0-9),(0-18,31)
OK
AT+CGQMIN?
+CGQMIN: 1,2,4,3,9,10
+CGQMIN: 2,2,4,3,9,10
+CGQMIN: 3,2,4,3,9,10
OK
+CGQREQ, Quality of Service Profile (Requested)
This command enables the terminal to specify a Quality of Service Profile that is used when the
ME sends an Activate PDP Context Request message to the network.
ME sends an Activate PDP Context Request message to the network.
Command
Type
Syntax
Response/Action
Remarks
Set
AT+CGQREQ=[<cid>
[,<precedence>
[,<delay>
[,<reliability.> [,<peak>
[,<mean>]]]]]]
[,<delay>
[,<reliability.> [,<peak>
[,<mean>]]]]]]
OK
or:
+CME ERROR: <err>
The Set command specifies a
profile for the context identified
by the (local) context
identification parameter, <cid>.
As this is the same parameter
that is used in the +CGDCONT
command, the +CGQREQ
command is effectively an
extension of the +CGDCONT
command. The QoS profile
consists of a number of
parameters, each of which may
be set to a separate value.
A special form of the Set
command, +CGQREQ= <cid>,
causes the requested profile for
context number <cid> to become
undefined.
profile for the context identified
by the (local) context
identification parameter, <cid>.
As this is the same parameter
that is used in the +CGDCONT
command, the +CGQREQ
command is effectively an
extension of the +CGDCONT
command. The QoS profile
consists of a number of
parameters, each of which may
be set to a separate value.
A special form of the Set
command, +CGQREQ= <cid>,
causes the requested profile for
context number <cid> to become
undefined.
Read
AT+CGQREQ?
+CGQREQ: <cid>,
<precedence>, <delay>,
<reliability>, <peak>, <mean>
<reliability>, <peak>, <mean>
OK
or:
+CME ERROR: <err>
The Read command returns the
current settings for each defined
context.
current settings for each defined
context.
Test
AT+CGQREQ=?
+CGQREQ: <PDP_type>,
(list of supported
<precedence>s), (list of
supported <delay>s), (list of
supported <reliability>s), (list
of supported <peak>s), (list of
supported <mean>s)
<precedence>s), (list of
supported <delay>s), (list of
supported <reliability>s), (list
of supported <peak>s), (list of
supported <mean>s)
OK
or:
+CME ERROR: <err>
The Test command returns
values supported as a compound
value. If the ME supports several
PDP types, the parameter value
ranges for each PDP type are
returned on a separate line.
values supported as a compound
value. If the ME supports several
PDP types, the parameter value
ranges for each PDP type are
returned on a separate line.