NDC comm NWH2610 用户手册
Read through the next section ‘Plan the Network’, in order to get the best possible
performance from the InstantWave wireless network.
Step 1: Plan the wireless network
Refer to Plan the Network, page 17, for
details
details
Step 2: Pre-configure the AP, WWB,
or WEC before installing it
into an existing Ethernet
network
into an existing Ethernet
network
Refer to Hardware Pre-Configuration, page
27, for details.
If you wish to use the default settings for a
simple wireless infrastructure network or
single AP network, you may skip this step
27, for details.
If you wish to use the default settings for a
simple wireless infrastructure network or
single AP network, you may skip this step
Step 3: Install the AP, WWB, or
WEC into the Ethernet
network
network
Refer to Hardware, page 54, for details.
Note: If your network is a simple wireless
infrastructure network, you need only place
the AP in a suitable location to finish the AP
installation
Note: If your network is a simple wireless
infrastructure network, you need only place
the AP in a suitable location to finish the AP
installation
Step 4: Make online configuration
and manage the AP, WWB,
or WEC via the IWMS
utility
or WEC via the IWMS
utility
Refer to Install the InstantWave
Management , page 27, and Using the
InstantWave Management , page 28, for
details
Management , page 27, and Using the
InstantWave Management , page 28, for
details
InstantWave
11Mbps
WWB/WEC
16