NDC comm NWH2610 用户手册

The WWB powers up,
but the Ethernet Link
LED is OFF (no
connection to an
Ethernet network).

Make sure:
1. The Ethernet cable is connected firmly to both the

WWB and Hub/Switch.

2. The Hub/Switch is powered on.

The Status LED on the
WWB panel is Red and
flashing.

Restart (power cycle) the WWB and check the Status
LED again. If it is still flashing, you need to return
the WWB to the reseller for repair.

Transmission
performance is slow or
erratic.

1. Move your WWB closer to the AP to find a better

signal. If the signal is still weak, change the
direction of the antenna slightly.

2. There may be interference, possibly caused by a

microwave oven, 2.4GHz wireless phone, or metal
objects. Move these interference sources or
change the location of the wireless PC or AP.

3. Change the wireless channel on the AP.

4. Check the WWB antenna, connectors, and cabling

are firmly connected

The AP and WWB are
working, but the PC
cannot connect to the
Ethernet network via the
AP.

1. The AP’s MAC access control function is enabled

and the WWB is denied access.

2. The Protocol Filter has blocked required protocols,

e.g. TCP/IP to the PC. Uncheck these protocols
from the filtering list. See Figure 16, page 34.

3. The IP settings on the PC are not correct.

InstantWave

11Mbps

WWB/WEC