Asrock K7NF2-raid K7NF2-RAID 用户手册

产品代码

K7NF2-RAID

1 6

2.8 Connectors

Connectors are N O T jumpers. DO N O T place jumper caps over

these connectors. Placing jumper caps over the connectors will

cause permanent damage of the motherboard!

FD D Connector

(33-pin FLOPPY1)

(see p.8 item 18)

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the

connector.

Primary IDE Connector (Blue)

Secondary IDE Connector (Black)

(39-pin IDE1, see p.8 item 11)

(39-pin IDE2, see p.8 item 12)

Note: If you use only one IDE device on this motherboard, please set the IDE

device as “Master”. Please refer to the instruction of your IDE device vendor

for the details. Besides, to optimize compatibility and performance, please

connect your hard disk drive to the primary IDE connector (IDE1, blue) and

CD-ROM to the secondary IDE connector (IDE2, black).

Serial ATA Connectors

These two Serial ATA (SATA)

(SATA1: see p.8 item 9)

connectors support SATA data

(SATA2: see p.8 item 8)

cables for internal storage

devices. The current SATA

interface allows up to 1.5 Gb/s

data transfer rate.

Serial ATA (SATA)

Either end of the SATA data cable

Data Cable

can be connected to the SATA

hard disk or the SATA connector

on the motherboard.

FLOPPY1

Pin1

IDE1

PIN1

IDE2

PIN1

connect the black end

to the IDE devices

connect the blue end

to the motherboard

80-conductor ATA 66/100/133 cable

the red-striped side to Pin1

SATA1

SATA2