Nortel Networks 4050 用户手册
Chapter 18 Troubleshooting 841
Nortel Secure Network Access Switch 4050 User Guide
Cannot add the Nortel SNAS 4050 to a cluster
When you try to add a Nortel SNAS 4050 device to a cluster by selecting
join
in
the Setup menu, you may receive an error message stating that the system is
running an incompatible software version.
running an incompatible software version.
The incompatible software version referred to in the error message is the software
that is running on the Nortel SNAS 4050 device you are trying to add to the
cluster. This error message is displayed whenever the Nortel SNAS 4050 you are
trying to add has a different software version from the Nortel SNAS 4050 device
already in the cluster. In this situation, do one of the following:
that is running on the Nortel SNAS 4050 device you are trying to add to the
cluster. This error message is displayed whenever the Nortel SNAS 4050 you are
trying to add has a different software version from the Nortel SNAS 4050 device
already in the cluster. In this situation, do one of the following:
•
Adjust the software version on the Nortel SNAS 4050 device you are trying to
add to the cluster, to synchronize it with the software version running on the
Nortel SNAS 4050 device already in the cluster. You can verify software
versions by typing the command
add to the cluster, to synchronize it with the software version running on the
Nortel SNAS 4050 device already in the cluster. You can verify software
versions by typing the command
/boot/software/cur
. The active
software version is indicated as
permanent
.
To adjust the software version on the Nortel SNAS 4050 device you want to
add to the cluster, you must either upgrade to a newer software version or
revert to an older software version. In either case, perform the steps described
in
add to the cluster, you must either upgrade to a newer software version or
revert to an older software version. In either case, perform the steps described
in
. After you adjust the software
version, log on as the Administrator user and select
join
from the Setup
menu.
•
Upgrade the software version running on the Nortel SNAS 4050 device in the
cluster to the same version as running on the Nortel SNAS 4050 you want to
add to the cluster. Perform the steps described in
cluster to the same version as running on the Nortel SNAS 4050 you want to
add to the cluster. Perform the steps described in
. Then add the Nortel SNAS 4050 device
by selecting
join
from the Setup menu.
Cannot contact the MIP
When you try to add a Nortel SNAS 4050 to a cluster by selecting
join
in the
Setup menu, you may receive an error message stating that the system is unable to
contact the Management IP address (MIP).
contact the Management IP address (MIP).