Nortel Networks MSC8101 ADS 用户手册
MOTOROLA
MSC8101ADS RevB User’s Manual
21
Installation Instructions
FIGURE 3-3 Stand Alone Configuration
3•4
+5V Power Supply Connection
The MSC8101 requires +5V DC @ 4A max, power supply for operation. Connect the +5V power
supply to connector P26 as shown below:
supply to connector P26 as shown below:
FIGURE 3-4 P26: +5V Power Connector
P26 is a 3 terminal block power connector with power plug. The plug is designed to accept 14 to
22 AWG wires. It is recommended to use 14 to 18 AWG wires. To provide solid ground, two GND
terminals are supplied. It is recommended to connect both GND wires to the common of the power
supply, while “Hot” line is connected with a single wire.
22 AWG wires. It is recommended to use 14 to 18 AWG wires. To provide solid ground, two GND
terminals are supplied. It is recommended to connect both GND wires to the common of the power
supply, while “Hot” line is connected with a single wire.
NOTE
Since hardware applications may be connected
to the MSC8101ADS via the expansion connec-
tors P1 and P2, the additional power consump-
tion should be taken into consideration when a
power supply is connected to the MSC8101ADS.
to the MSC8101ADS via the expansion connec-
tors P1 and P2, the additional power consump-
tion should be taken into consideration when a
power supply is connected to the MSC8101ADS.
3•5
JTAG/OnCE Connector - P6
The MSC8101ADS JTAG/OnCE connector, P6, is a 14 pin, two rows, header connector with key.
The connection between the MSC8101ADS and the Command Converter is by a 14 line flat cable,
The connection between the MSC8101ADS and the Command Converter is by a 14 line flat cable,
Host
Computer
5V Power Supply
Et
he
rne
t
Ne
tw
ork
ATM155(Optic)
RS2
32
T1/E1
four ch.
Audio
Stereo
Stereo
+5V
GND
1
2
GND
3
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
c
.
..