Extron electronic IPL T PC1i 产品宣传页

Connectors

IPL T PC1 ..........................  1 female USA/Edison power connector
IPL T PC1i .........................  1 female IEC power connector

Voltage

IPL T PC1 ..........................  120 VAC, 50-60 Hz
IPL T PC1i .........................  220 VAC, 50-60 Hz

Maximum AC load

IPL T PC1 ..........................  12 A, 1440 watts at 120 VAC
IPL T PC1i .........................  10 A, 2200 watts at 220 VAC

Serial control port ........................  (1) RS-232 only, 3.5 mm captive screw connectors, 4 pole 
Baud rate and protocol ...............  115200 to 300 baud (9600 baud = default) ; 8 (default) or 7 data bits; 1 (default) or 2 

stop bits; no parity (default), or even or odd parity 

Serial control pin configurations  1 = TX, 2 = RX, 3 = GND, 4 = +5 VDC 

Connector ......................................  1 RJ-45 female connector
Data rate ........................................  10/100Base-T, half/full duplex with autodetect
Protocols .......................................  ARP, DHCP, ICMP (ping), TCP/IP, UDP/IP, Telnet, HTTP, SMTP
Default settings ............................  Link speed and duplex level = autodetected

IP address = 192.168.254.254 
Subnet mask = 255.255.0.0 
Gateway = 0.0.0.0 
DHCP = off 

Web server ....................................  Up to 200 simultaneous sessions

7.25 MB nonvolatile user memory

Program control ...........................  Extron’s Simple Instruction Set (SIS

™

)

Global Viewer requirements ......  Microsoft

®

 Internet Explorer ver. 6 or higher

Quantity/type ..............................  1 contact closure input
Contact input control connector .  (1) 3.5 mm captive screw connector, 4 pole (shared with IR output port)
Contact closure (input only)

Input voltage range .........  0 to 5 VDC, clamped at +5.1 V
Input impedance ..............  10k ohms
Threshold ..........................  1.6 VDC

Pin configuration .........................  1 = contact input,  2 = GND

IR control port ..............................  (1) 3.5 mm captive screw connector, 4 pole (shared with contact closure input port)
Pin configurations .......................  3 = S (IR signal output), 4 = GND
IR output carrier frequency ........  30 kHz to 1 MHz

Power input ..................................  100 VAC to 240 VAC, 50/60 Hz, 5 watts, internal, on 1 male IEC power connector

IPL T PC1 ..........................  12 A (max.)
IPL T PC1i .........................  10 A (max.)

Temperature/humidity ..............  Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing

Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing

Cooling ..........................................  Convection, unvented