GE 23954 用户手册

2.2.8  Snmp command group 

The snmp command group allows to configure the SNMP Agent for UPS monitoring via SNMP and trap 
notification of UPS events and alarms: 
 
 

 

Show detailed system information 

[port] 

Set SNMP server listening port (*) 
[port] SNMP 

port 

NOTE: Default SNMP port is 161. 

on | off 

Enable/disable SNMP Agent 
on  

SNMP Agent enabled 

off  

SNMP Agent disabled 

[contact] (**) 

Set the system contact 
[contact] contact 

person 

NOTE: The syscontact parameter is the identification of 
the contact person for the managed node. 

[location] (**) 

Set the system location 
[location] location 

name 

NOTE: The syslocation parameter is the identification of 
the physical location of the managed node. 

Defines the community name for receiving SNMP 
information (GET). 
[community] community 

name 

[community] 

NOTE: The get community name controls access to the 
SNMP Agent – the community in the request must match 
the getcommunity parameter. 
The default value is public. 

Defines the community name for writing SNMP 
information (SET). 
[community] community 

name 

NOTE: The set community name controls access to the 
SNMP Agent – the community in the request must match 
the setcommunity parameter. 
The default value is private. 

[community] 

 
(*) Changing the port causes the SNMP Agent to restart. This might have a temporary effect also on trap 
notification. 
 
(**) Both parameters have a maximum length of 63 chars. If these parameters contain blanks or special 
characters they shall be specified in between double quotation marks (“...”) .  

Modifications reserved 

Page 21/58 

OPM_CNT_SNM_BAS_CRD_1GB_V012.doc 

Operating Manual SNMP/Web Adapter