Sun Microsystems 2.0 用户手册
Chapter 2
Hardware Installation and Removal
19
3. When the blue Ready-to-Remove LED is lit on the NEM, physically remove the
NEM.
a. Remove all cables from the NEM.
b. Press the latch on both ejector levers inward at the same time.
c. Swing out the ejector levers to their fully open position.
d. Slide the NEM out of its slot.
Support the weight of the NEM with one hand at the bottom of the NEM.
▼
To Replace the ID Chip
1. After you have removed the failed NEM from the chassis, locate the ID chip at the
back of the board (see
).
FIGURE 2-6
Location of ID Chip
2. Grasp the edges of the ID chip and pull straight up to remove it from the board.
3. Remove the ID chip from the new NEM, and install it onto the failed board that
you will be returning to Sun.
ID chip