Sun Microsystems 2.0 用户手册
35
Safety Agency Compliance
Statement
Statement
Read this section before beginning any procedure. The
following text provides safety precautions to follow when
installing a Sun Microsystems product.
following text provides safety precautions to follow when
installing a Sun Microsystems product.
Safety Precautions
For your protection, observe the following safety
precautions when setting up your equipment:
precautions when setting up your equipment:
■
Follow all cautions and instructions marked on the
equipment.
equipment.
■
Ensure that the voltage and frequency of your power
source match the voltage and frequency inscribed on
the equipment’s electrical rating label.
source match the voltage and frequency inscribed on
the equipment’s electrical rating label.
■
Never push objects of any kind through openings in
the equipment. Dangerous voltages may be present.
Conductive foreign objects could produce a short
circuit that could cause fire, electric shock, or damage
to your equipment.
the equipment. Dangerous voltages may be present.
Conductive foreign objects could produce a short
circuit that could cause fire, electric shock, or damage
to your equipment.
Symbols
The following symbols may appear in this book:
Caution –
There is a risk of personal injury
and equipment damage. Follow the
instructions.
instructions.
Caution –
Hot surface. Avoid contact.
Surfaces are hot and may cause personal
injury if touched.
injury if touched.
Caution –
Hazardous voltages are present. To
reduce the risk of electric shock and danger to
personal health, follow the instructions.
personal health, follow the instructions.
Depending on the type of power switch your device has,
one of the following symbols may be used:
one of the following symbols may be used:
On –
Applies AC power to the system.
Off –
Removes AC power from the system.
Standby –
The On/Standby switch is in the
standby position.
Modifications to Equipment
Do not make mechanical or electrical modifications to the
equipment. Sun Microsystems is not responsible for
regulatory compliance of a modified Sun product.
equipment. Sun Microsystems is not responsible for
regulatory compliance of a modified Sun product.
Placement of a Sun Product
Caution –
Do not block or cover the openings
of your Sun product. Never place a Sun
product near a radiator or heat register.
Failure to follow these guidelines can cause
overheating and affect the reliability of your
Sun product.
product near a radiator or heat register.
Failure to follow these guidelines can cause
overheating and affect the reliability of your
Sun product.
Noise Level
Declared noise emissions in accordance with ISO 9296,
A-weighted, operating and idling:
A-weighted, operating and idling:
SELV Compliance
Safety status of I/O connections comply to SELV
requirements.
requirements.
Measure and Environment
L
wAd
(1B = 10 dB)
at or below 25ºC
8.0 B
at max ambient
8.4 B
L
pAm
bystander
at or below 25ºC
66 dB
at max ambient
69 dB