Sun Microsystems 3U 用户手册
Chapter 4
Configuring the SunATM Interfaces
33
If you are planning to run NIS over your ATM network, you must specify the list of
NIS servers (ypservers) using the
NIS servers (ypservers) using the
ypinit -c
command. See the
ypinit(1M)
man
page for details of setting up the ypserver. Be sure that the IP addresses of the
ypservers are listed in the
ypservers are listed in the
/etc/hosts
file.
The Routing Information Protocol (RIP) also uses the broadcast feature of IP, so it is
not supported under the Classical IP environment. In the Solaris operating
environment, RIP is implemented by the daemon
not supported under the Classical IP environment. In the Solaris operating
environment, RIP is implemented by the daemon
in.routed
.
Classical IP alone also does not support the multicast packet delivery system. If you
are using Classical IP, you must explicitly add the routes to the routers in the ATM
subnet. You may also specify one router as the default router to provide connectivity
outside of the ATM subnet. See the
are using Classical IP, you must explicitly add the routes to the routers in the ATM
subnet. You may also specify one router as the default router to provide connectivity
outside of the ATM subnet. See the
route(1M)
man page for information on using
the route command to add specific router entries and to add a default router.
You can use the Classical IP parameter group menu to define the Classical IP
configuration of a SunATM interface.
configuration of a SunATM interface.
Classical IP Interface Type
The SunATM software allows you to configure your interface as either a Classical IP
ARP server or a client. In addition, you can connect two systems back-to-back, in a
standalone configuration, using a Permanent Virtual Circuit (PVC). These three
modes are options on the Classical IP parameter menu.
ARP server or a client. In addition, you can connect two systems back-to-back, in a
standalone configuration, using a Permanent Virtual Circuit (PVC). These three
modes are options on the Classical IP parameter menu.
Modifying ba0; Current Configuration:
Arp Client
IP = atm_cip
ATM = $myaddress
ARPSRV = $localswitch_server
[N] No Classical IP Enabled
[C] Client
[S] Arp Server
[T] Standalone
[I] Hostname or IP Address
[L] Local ATM Address
[A] ATM ARP Server Address
[P] Previous Menu
[M] Main Menu
[X] Exit
[?] Help
Enter Selection: