GE superbus 2000 concord 4 gsm module 用户手册

466-2262A • October 2006

Copyright © 2006, GE Security Inc.

This is the GE SuperBus 2000 Concord 4 GSM Module Installa-
tion Instructions for part number 600-1053. The module can be 
used on Concord 4.0 and higher.
The module interfaces with the Concord panel data bus and is 
powered by the panel battery or an auxiliary 12 VDC power 
supply. Status LEDs indicate bus and paging network communi-
cations. A supervised zone input allows you to connect a hard-
wired contact. Figure 1 shows the location of the main module 
components and Table 1 describes the component functions.

Use the following tips to help guarantee your success with the 
Alarm.com Concord GSM Module:
1.

Make sure you create the customer account on the 
Alarm.com dealer website at least 24 hours before installa-
tion. See 

2.

Make sure you turn off the Access Code Lock feature.

3.

Use the LEDs on the module to check the signal strength 
before you permanently mount the module.

4.

Power the module off of the battery (see 

not off of the panel.

5.

Do a manual phone test to initiate communication (see 

Figure 2 shows the GSM status LEDs and Table 2 describes the 
LED functions. See 

 on page 5 for more infor-

mation.

PWR LED

Indicates module power status.

BUS LED

Indicates data bus activity between the panel and 

module.

AUTO LED

Indicates module/data transceiver communication.

Status LEDs

Indicates communications status with GSM network.

Wiring terminals

Provides panel and zone wiring connections.

Antenna jack

Antenna connection for wireless data transceiver.

GSM status LEDs

Indicates communication with the GSM network, 

report errors, and signal strength.

Serial number

A 15-digit number beginning with 35323900. Only the 

last 10 digits, starting with 900, are used for account 

activation.

LED 1

Error LED. Will slash 1 to 8 times in a four-second 

interval to indicate specific error conditions such as a 

network error, panel communication error, or GSM 

radio error.

LED 2

Panel communication LED. Flashes every time a data 

packet is received from the panel.

LED 3

GSM communication LED. Flashes every time a data 

packet is received from the GSM radio.

LED 4

GSM signal level LED. Flashes 0 to 5 times, or toggles 

on/off when communicating with the Alarm.com 

servers.

L1       L2        L3        L4