TDK blu2i 用户手册

 
Congratulations on your purchase of the TDK Systems blu

2i

 Module. 

 
The Module is designed to be built into a device and to provide a simple, 
low cost Bluetooth interface. The module is designed to integrate with a 
wide range of applications and platforms with a simple electrical and 
software interface using AT commands. 
 
This guide aims to provide all the electrical and mechanical information 
needed to design applications using the blu

2i

 Module. A separate 

document, blu

2i

 Module - AT Command Set, outlines the protocol for the 

software interface. 
 

 
The following safety precautions must be observed during all phases of 
the operation, usage, service or repair of any application incorporating 
this Bluetooth Module. Manufacturers of the RF equipment are advised 
to convey the following safety information to users and operating 
personnel and to incorporate these guidelines into all manuals supplied 
with the product. Failure to comply with these precautions violates safety 
standards of design, manufacture and intended use of the product. TDK 
Systems assumes no liability for customer failure to comply with these 
precautions. 
 

 
The blu

2i

 Module is listed as a Bluetooth Product in terms of the 

Bluetooth SIG Program Reference Document (PRD). This means that it 
can be integrated into end products without further testing or approval 
listing. The manufacturer must state the TDK part number and product 
reference in his literature in order to meet the requirements of the 
Bluetooth and regulatory approvals. 
 
A list of the countries where the module is approved will be provided by 
TDK Systems as required. As a minimum the product is listed in Europe, 
Scandinavia and USA. TDK Systems assumes no liability for customer 
failure to comply with national RF approvals. 

3 of 36