Linksys FENSK05 用户手册
Setting Up Your EtherFast LAN Card for Wake-
On-LAN Use
On-LAN Use
1. Use the diagram below to locate the WOL pins and
the jumpers on the EtherFast LAN Card.
the jumpers on the EtherFast LAN Card.
2. Connect one end of the 3-pin Wake-On-LAN wire to
the EtherFast LAN Card.
the EtherFast LAN Card.
3. Now you need to set the jumpers on your card
according to whether your motherboard supports RWU-
high, RWU-low, or PME. Keep in mind that the jumpers
are numbered backwards: the numbers read right to left
and down to up.
according to whether your motherboard supports RWU-
high, RWU-low, or PME. Keep in mind that the jumpers
are numbered backwards: the numbers read right to left
and down to up.
If your motherboard supports Remote Wake-Up High
(RWU-high), set your jumpers like this:
(RWU-high), set your jumpers like this:
If your motherboard supports Remote Wake-Up Low
(RMU-low), set your jumpers like this:
(RMU-low), set your jumpers like this:
If your motherboard supports Power Management
Event (PME), set your jumpers like this:
Event (PME), set your jumpers like this:
48
Wake-On-LAN