XiNCOM XC-DPG503 用户手册

Policy Setup

IPSec Traffic Binding

It shows the tunnels that you have entered. The router can setup up to 50 tunnels
Tunnel Name

This distinguishes different “tunnels” by name.
Tunnel 

The tunnel can only be connected when the Enable check box is selected.
WAN port 

You can choose WAN1, WAN2 or Any to make the VPN connection.
PPPoE Session

Some ISPs offer multiple sessions when using PPPoE to make the  VPN connection.  You can 

select these PPPoE sessions to construct VPN tunnels.

Traffic Selector

Protocol Type: You can choose either TCP/UDP/ICMP/GRE protocol as your connection protocol. 

By default the protocol type is “Any”.
Local Security Network

These entries identify the private network on the VPN gateway and the hosts of which can use the 

LAN-to-LAN connection. You can choose a single IP address, the subnet, or a selected IP range to 

make VPN LAN-to-LAN connection.
Remote Security Network

These entries identify the private network on the remote peer VPN router whose hosts can use the 

LAN-to-LAN connection. You can choose a single IP address, the subnet, or a selected IP range to 

make VPN connection
Remote Security Gateway

You can either select remote side domain name or remote side IP address (WAN IP address) as 

your remote side security gateway.

Security Level

It specifies the encryption mechanism to use. Data encryption makes the data unreadable if 

intercepted. There are three encryption method available: DES, 3DES and AES. The default is 

null. 
Authentication 

This specifies the packet authentication mechanism to use. Packet authentication confirms the 

data’s source. There are three authentications available: MD5, SHA1 and SHA2. 

36