XiNCOM XC-DPG503 用户手册

45

Advanced LAN Configuration

Static Routing
This section is only relevant if your LAN has other Routers or Gateways.

If you do not have other Routers or Gateways on your LAN, skip the Static Routing page.
If your LAN has other Gateways and Routers, you must configure the Static Routing screen as described below. You also need to configure the other Routers.

Note: If there is an entry or entries in the Routing table with an Index of zero ( 0 ), these are System entries. You can not modify or delete these entries.

Settings - Static Routing

• If adding a new entry, skip this field.

• To edit an existing entry, select it from the list, and click the “Select” button. The screen will then update with the data for the selected entry.

• If the Index is 0, this is a System entry which you can neither delete nor modify.

Network Address The network address of the remote LAN segment. For standard class “C” LANs, the network address is the first 3 fields of the Destination IP Address. The 4th (last) field 

can be left at 0.

The Network Mask for the remote LAN segment. For class “C” networks, the default mask is 255.255.255.0

The IP Address of the Gateway or Router which the XC-DPG503 must use to communicate with the destination above. (NOT the router attached to the remote segment.)

Select the correct interface (usually LAN). The WAN interface is only available if NAT (Network Address Translation) is disabled.

The number of “hops” (routers) to pass through to reach the remote LAN segment. The shortest path will be used.