Enfora 600/650 用户手册

 

WLN1501/WLN1502 Wi-Fi Adapter 

 

Page 6 

Copyright, 2005 Enfora, Inc. 

 
 
Battery Operation 

 
Prior to using the Enfora® Wi-Fi® Adapter, charge the new battery for a minimum of 2 hours 
to obtain a full charge.  The Enfora® Wi-Fi® Adapter derives its power from a self-contained 
battery pack to ensure there is no battery drain on the handheld device. 
 
The Enfora® Wi-Fi® Adapter will also charge your Treo 600/650 Smartphone if the Treo 
600/650 is placed in the Enfora® Wi-Fi® Adapter.   
 

Note:  The Enfora® Wi-Fi® Adapter WILL NOT act as a spare 

battery for the Treo Smartphone.

 
To power down the Enfora® Wi-Fi® Adapter, hold down the power button for three 
seconds, until the adapter turns off. 
 
System Requirements 
 

Check your hardware and software to see if they satisfy the requirements below. If you are not 
sure, please consult your dealer or operator. 
 

•  Treo 600 

OR 

•  Treo 650 (with the updated battery cover attached) 

 

 
Software Installation 
 

1.  Insert the CD that came with your Enfora® Wi-Fi® Adapter into your computer’s 

CD drive. 

2.  If the enclosed CD-ROM does not start automatically, run the Enfora program 

EnforaWiFi.exe and follow the Install Wizard.  The Enfora program is located on 
the CD-ROM in the install directory. 

3.  After completing the installation you will be prompted to perform a Hot Sync® 

synchronization.  This will install all necessary drivers and software to your Treo 
600/650.  (Please refer to the Treo Users’ Manual for details on HotSync®.) 

4.  Dock your Treo 600/650 device in its cradle, or connect the sync cable, and 

perform Hot Sync®.