VIVOTEK IP3111/IP3121 用户手册

 

 
 
 
 
 

www.vivotek.com

 

  

T: 

886-2-22404099 

  

F: 

886-2-22404097 

 

 
 
 
 
 
 

15

Software configuration 

In order to configure NetworKams remotely, administrators should keep the serial numbers of the new 

NetworKams for identification and initial passwords. After successfully mounting NetworKams in the 

proper position, run the Installer program on the appropriate PC to locate the newly installed 

NetworKams. NetworKams also support manual setup procedures to non-Windows based environments. 

The manual procedure is described next. 

 

After the POST is done, NetworKam will try to configure itself by detecting the network environment. If 

there is DHCP service over the network, the Installer program will catch the given information and 

display the serial number and given IP address for each NetworKam as following figure. If no DHCP 

service is available, a previous IP address will be displayed instead. In that case, it may be 0.0.0.0 for a 

brand new unit. When multiple units are mounted, there may be several entries shown in the window. 

Administrators may click on each entry with "Assigned" field labeled "No" to install sequentially.