Raritan Computer IPR-TR364 用户手册
C
HAPTER
4:
A
DMINISTRATIVE
F
UNCTIONS
41
Network Configuration
After making changes to the Network Configuration, press <Ctrl+S> to save. You must reboot when all
changes are complete in order to apply them.
changes are complete in order to apply them.
•
Name: Designate a unique name for this IP-Reach unit, for example, “Miami Data Center.” The
default name is IP-Reach.
•
Enable Ethernet Interface: Designates whether IP-Reach should enable its Ethernet adapter as active
(default: YES).
Note: Network connections must be 10BASE-T or 100BASE-TX Ethernet
-
Line Speed & Duplex: Auto detect 10 Mbps/Full Duplex, 10 Mbps/Half Duplex, 100
Mbps/Full Duplex, or 100 Mbps/Half Duplex
Mbps/Full Duplex, or 100 Mbps/Half Duplex
-
Obtain IP address automatically (DHCP):
♦
YES: Enables dynamic IP addressing for IP-Reach. Each time IP-Reach boots, it will
request an IP address from the local DHCP server. Note that this setting can make remote
access to IP-Reach from outside the LAN difficult, since the dynamically assigned IP
address must be known in order to initiate a connection.
access to IP-Reach from outside the LAN difficult, since the dynamically assigned IP
address must be known in order to initiate a connection.
♦
NO (default): Assigns a fixed IP address to the IP-Reach unit (recommended).
IP Address: Enter the IP address for IP-Reach given by your Network
Administrator.
Subnet Mask: Enter a Subnet Mask provided by your Network
Administrator.
Default Gateway: Enter the Default Gateway if your Network Administrator
specifies one.
•
Enable Modem Interface: Enables Dial-up Modem access (default: YES). For IP-Reach M Series, an
external serial modem must be connected in order for this function to work properly (see Chapter 2:
Installation, M Series Physical Connections, Dedicated Modem Port).
Installation, M Series Physical Connections, Dedicated Modem Port).
•
Enable Web Browser Interface: Enables web browser access to IP-Reach (default: YES).
•
Use Default TCP Port 5000:
-
YES (default): Utilizes the default port 5000.
-
NO Enter an alternate port number.
Note: In order to access IP-Reach from beyond a firewall, your firewall settings must enable two-way
communication through the default port 5000, or the non-default port configured above.
communication through the default port 5000, or the non-default port configured above.