Raritan Computer Paragon II 用户手册
A
PPENDIX
B:
U
SER
S
TATION
D
IRECT
M
ODE
85
Appendix B: User Station Direct Mode
A Paragon User Station set to Direct Mode can be directly connected to a Paragon CIM, either
temporarily for emergency “crash cart” access or permanently for non-switched extension
purposes, without having to go through a Base Unit.
temporarily for emergency “crash cart” access or permanently for non-switched extension
purposes, without having to go through a Base Unit.
To make this kind of “Direct Mode” connection, take these steps:
1. If you have not already done so, follow the instructions in steps 5A and 5B of Chapter 2:
Installation, Installing a Paragon System with a Single Base Unit to attach the CIM to the
CPU.
CPU.
2. If you have not already done so, plug in and power ON your target server/computer.
3. Power off the User Station.
4. Run CAT5 cabling directly between the User Station and the CIM.
5. Power ON the UST. It should display a “DIRECT Mode: CIM connected” message on the
3. Power off the User Station.
4. Run CAT5 cabling directly between the User Station and the CIM.
5. Power ON the UST. It should display a “DIRECT Mode: CIM connected” message on the
LCD panel.
While the User Station is in Direct Mode, if the CAT5 cabling between the User Station and the
P2CIM-PS2 becomes disconnected at any point for more than three to four seconds, the User
Station will exit Direct Mode. To re-establish Direct Mode, repeat the above steps.
P2CIM-PS2 becomes disconnected at any point for more than three to four seconds, the User
Station will exit Direct Mode. To re-establish Direct Mode, repeat the above steps.
To return a User Station that’s in Direct Mode to normal operation, take these steps:
1. Power OFF the User Station.
2. Disconnect the opposite end of the CAT5 cabling from the CIM.
3. Connect the opposite end of the CAT5 cabling to a user port of a Base Unit.
4. Run other CAT5 cabling from the channel port of a Base Unit to the CIM.
5. Power ON the User Station.
2. Disconnect the opposite end of the CAT5 cabling from the CIM.
3. Connect the opposite end of the CAT5 cabling to a user port of a Base Unit.
4. Run other CAT5 cabling from the channel port of a Base Unit to the CIM.
5. Power ON the User Station.