Rosewill RNX-N300 用户手册

13 

The Network tab displays the current status of the wireless radio.  The following information is 
included in this tab, as the image depicts below. 
 

 

 

•  Status: This indicates the state of the client. There are three options: 

1.

 Associated: Indicates that the wireless client is connected to an Access Point (AP).  The 

BSSID is shown in the form of 12 HEX digits, which is the MAC address of the AP. 

2.

 Scanning: Indicates that the wireless client is searching for an AP in the area. 

3.

 Disconnected: Indicates that there are no APs or clients in the area.  

•  Extra Info: Displayed here are information about the link stats and the percent of output 

power.  

•  Current Channel: The operating frequency channel that the client is using (infrastructure 

mode).  

•  Link Speed: The current rate at which the client is transmitting and receiving. 

•  Throughput (bytes/sec): Displays the Tx (transmit) and Rx (receive) kilo-bytes per second. 

•  Link Quality: In infrastructure mode, this bar displays the transmission quality between an 

AP and a client. In Ad-hoc mode, this bar displays the transmission quality between one 
client, and another. 

•  Signal Strength: This bar displays the strength of the signal received from an AP or client. 

•  Noise Level: Displays the background noise level; a lower level indicates less interference.  

•  Click on the OK button to close this window. 

•  dBm Check Box. When you click on the check box as the drawing below. The signal 

strength and noise level will be shown as the dBm measurements.