Renesas M30880T-EPB 用户手册

M30880T-EPB User’s Manual 

3. Usage (How to Use the Emulator Debugger) 

REJ10J0497-0100Z  Rev.1.00  January 16, 2005 

 

Page 48 of 100 

 

3. Usage (Emulator Debugger) 

 
This chapter describes how to start up the emulator debugger and how to use the major windows. 
 

3.1 Starting Up the Emulator Debugger (Init Dialog Box) 

To launch the emulator debugger, click the Start menu of Windows and then select 

Program (P) >> [RENESAS-TOOLS] >> [PD308F V.xx.xx Release x] >> [PD308F]. 

When the emulator debugger started up, the Init dialog box appears. 
 
(1) MCU tab 
 
1. Specifying the MCU file 

 
2. Specifying the communication interface (LPT communication) 

 

Specifying the MCU file 

Click the “Refer...” button. 

A file selection dialog box will be displayed, so select the

desired MCU file. The MCU file is stored in the directory in

which you installed the M3T-PD308F. 

(Example: c:\mtool\PD308F\mcufiles) 

-  The MCU file contains the information specific to the

target MCU. 

-  The MCU file you have selected is displayed in the MCU

section of the MCU tab. 

Specifying the communication interface
(LPT communication) 

For selecting the LPT communication, click the radio button

“LPT” of the MCU tab. Specify the using LPT

communication mode at the Type area. Specify the I/O

address of the parallel port at the I/O address area. For BIOS

setup, the following addresses are available. 

- 378h 

- 278h