Renesas M3T-MR100 用户手册

   

266 

 

User stacks must be calculated for each task. The following shows an example for calculating user stacks in cases when an 
application is written in the C language and when an application is written in the assembly language. 

z

   When an application is written in the C language 

Using the stack size calculation utility of NC100, calculate the stack size of each task. The necessary stack size 
of a task is the sum of the stack size output by the stack size calculation utility plus a context storage area of 48 
bytes

   

z

 When an application is written in the assembly language 

♦  Sections used in user program 
The necessary stack size of a task is the sum of the stack size used by the task in subroutine call plus the size 
used to save registers to a stack in that task. 

♦  Sections used in MR100 
The sections used in MR100 refer to a stack size that is used for the service calls issued. 

MR100 requires that if you issue only the service calls that can be issued from tasks, 8bytes of area be allocated 
for storing the PC and FLG registers. Also, if you issue the service calls that can be issued from both tasks and 
handlers, see the stack sizes listed in Table 10.2 Stack Sizes Used by Service Calls Issued from Handlers (in 
bytes) to ensure that the necessary stack area is allocated.   

Furthermore, when issuing multiple service calls, include the maximum value of the stack sizes used by those 
service calls as the sections used by MR100 as you calculate the necessary stack size. 

 

Therefore, 

 + registers used + Sections used in MR100 

(registers used is total size of used registers.) 

Figure 2.3:Example of Use Stack Size Calculation shows an example for calculating a user stack. In the example below, the 
registers used by the task are R2R0, R3R1, and A0. 

                                                      

54

  If written in the C language, this size is fixed.