Renesas SH7630 用户手册

 

4 

 

To connect the E10A emulator (hereinafter referred to as the emulator), the H-UDI port connector 
must be installed on the user system to connect the user system interface cable.  When designing 
the user system, refer to the recommended circuit between the H-UDI port connector and the 
MCU.  In addition, read the E10A emulator user's manual and hardware manual for the related 
device. 

Table 1.2 shows the type number of the E10A emulator, the corresponding connector type, and the 
use of AUD function. 

HS7630KCM02H, HS7630KCI02H 

36-pin connector 

Available 

HS7630KCM01H, HS7630KCI01H 

14-pin connector 

Not available 

 

The H-UDI port connector has the 36-pin and 14-pin types as described below.  Use them 
according to the purpose of the usage. 

1.  36-pin type (with AUD function)  

The AUD trace function is supported.  A large amount of trace information can be acquired in 
realtime.  The E10A emulator supports the window trace function that memory access 
(memory access address or memory access data) in the specified range can be acquired by 
tracing. 

2.  14-pin type (without AUD function) 

The AUD trace function cannot be used because only the H-UDI function is supported.  For 
tracing, only the internal trace function is supported.  Since the 14-pin type connector is 
smaller than the 36-pin type (1/2.5), the area where the connector is installed on the user 
system can be reduced.