Renesas SH7700 Series 用户手册

 

 

28 

In the [Configuration] dialog box, if [User] is set while the [UBC mode] list box has been set, the 
STEP-type commands that use Break Condition 2 for implementation cannot be used.   

The SH7710 E10A emulator supports the performance measurement function. 

1.  Setting the performance measurement conditions 

To set the performance measurement conditions, use the [Performance Analysis] dialog box 
and the PERFORMANCE_SET command.  When any line on the [Performance Analysis] 
window is clicked with the right mouse button, the popup menu is displayed and the 
[Performance Analysis] dialog box is displayed by selecting [Setting]. 

 

Note:  For the command line syntax, refer to the online help. 

(a) Specifying the measurement start/end conditions 

The measurement start/end conditions are specified in the [Mode] drop-down list box in the 
[Performance Analysis] dialog box.  Three conditions can be set as shown in table 2.9. 

 

Normal break 

Measurement is started by executing a program and ended when a 
break condition is satisfied. 

Break Condition 1 -> 2 

Measurement is started from the satisfaction of the condition set in 
Break Condition 1 and ended with the satisfaction of the condition set in 
Break Condition 2. 

Break Condition 2 -> 1 

Measurement is started from the satisfaction of the condition set in 
Break Condition 2 and ended with the satisfaction of the condition set in 
Break Condition 1.