Renesas SH7700 Series 用户手册

3 

 

To connect the E10A emulator (hereinafter referred to as the emulator), the H-UDI port connector 
must be installed on the user system to connect the user system interface cable.  When designing 
the user system, refer to an example of recommended connection between the connector and the 
MPU shown in this manual.  In addition, read the E10A emulator user's manual and hardware 
manual for the related device. 

Table 1.2 shows the type number of the emulator, the corresponding connector type, and the use of 
AUD function. 

HS7710KCM02H, HS7710KCI02H 

36-pin connector 

Available 

HS7710KCM01H, HS7710KCI01H 

14-pin connector 

Not available 

 

The H-UDI port connector has the 36-pin and 14-pin types as described below.  Use them 
according to the purpose of the usage. 

1.  36-pin type (with AUD function)  

The AUD trace function is supported.  A large amount of trace information can be acquired in 
realtime.  The window trace function is also supported for acquiring memory access in the 
specified range (memory access address or memory access data) by tracing. 

2.  14-pin type (without AUD function) 

The AUD trace function cannot be used because only the H-UDI function is supported.  For 
tracing, only the internal trace function is supported.  Since the 14-pin type connector is 
smaller than the 36-pin type (1/2.5), the area where the connector is installed on the user 
system can be reduced.