Renesas SH7781 用户手册

21.   Serial Communication Interface with FIFO (SCIF) 

Rev.1.00  Jan. 10, 2008  Page 1096 of 1658 
REJ09B0261-0100 

 

Note the following when using the SCIF. 

The TDFE flag in SCFSR is set when the number of transmit data bytes written in SCFTDR has 
fallen to or below the transmit trigger count set by bits TTRG1 and TTRG0 in SCFCR. After 
TDFE is set, transmit data up to the number of empty bytes in SCFTDR can be written, allowing 
efficient continuous transmission. 

However, if the number of data bytes written in SCFTDR is equal to or less than the transmit 
trigger count, the TDFE flag will be set to 1 again, even after being read as 1 and cleared to 0. 
Therefore, the TDFE flag should be cleared when SCFTDR contains more than the transmit 
trigger count of transmit data bytes. 

The number of transmit data bytes in SCFTDR can be found from SCTFDR. 

The RDF flag in SCFSR is set when the number of receive data bytes in SCFRDR has become 
equal to or greater than the receive trigger count set by bits RTRG1 and RTRG0 in SCFCR. After 
RDF is set, receive data equivalent to the trigger count can be read from SCFRDR, allowing 
efficient continuous reception. 

However, if the number of data bytes read in SCFRDR is equal to or greater than the trigger count, 
the RDF flag will be set to 1 again even if it is cleared to 0. After the receive data is read, clear the 
RDF flag readout to 0 in order to reduce the number of data bytes in SCFRDR to less than the 
trigger count. 

The number of receive data bytes in SCFRDR can be found from SCRFDR. 

If a framing error (FER) is detected, break signals can also be detected by reading the SCIF_RXD 
pin value directly. In the break state the input values from the SCIF_RXD consists of all 0s, so the 
FER flag is set and the parity error flag (PER) may also be set. 

Although the SCIF stops transferring receive data to SCFRDR after receiving a break, the receive 
operation continues.