Renesas M16C FAMILY 用户手册

1 Contents of Product

1.4 Board Specification

Table 1-5 shows the USB Monitor Board Specification. When saving these products, put

them into the conductive bag. Store them into the container box which is used for shipping

as possible

Table 1-5 USB Monitor Board Specification

Item Description

Debug formula

Monitor program formula
ROM size: Approx. 1600 byte
* In the case of R8C/Tiny Series, 2K byte

RAM size: 128 byte
* In the case of M16C/80 Group, 256 byte
* In the case of M32C/80 Series, 256 byte
* In the case of R8C/Tiny Series, not used
Operation frequency: 700KHz or above

(Note1)

Operation mode: Single chip mode

Monitor program

Software break: 2 points to 8 points

(Note2)

USB microcomputer

M37641F8HP (8 bit USB flash microcomputer)

USB interface (J1)

USB2.0 full speed

Synchronous serial Interface

Target interface (J3)

Starter kit and 10 pin connector for target board connection

4.75V to 5.25V

(USB bus-powered supply or target supply enabled)

Operation voltage

3.0V to 3.6V (supply from target is necessary)

(Note3)

Power consumption

Max.50mA

Board size

70mm x 29mm
Temperature: 25±5°C (no corrosive gas)

Use environment condition
(at the time of operation)

Humidity: no condensation

Temperature: 25±5°C (no corrosive gas)

Use environment condition
(at the time of storage)

Humidity: no condensation

Note 1: Maximum operating frequency is dependent on the MCU.

Note 2: Software break numbers are dependent on the address match circuit numbers

are built-in MCU.

Note 3: When operating in 3.3V, supply power from the target board. In this case, it is not

possible to change the FoUSB firmware. When the model name of the

microcomputer to be used is changed, remove the target board, supply the USB

bus-powered and rewrite the firmware.