RGB Spectrum Quadra User's Guide 用户手册

. 

. .

 . 

.

Quadra responds with the following message:

The system must be restarted for your changes to 

take effect. Do you want to restart the system 

(y/n)?

~

Press “

” to restart Quadra and use the newly assigned IP 

address.

~

Press “

” to retain the current IP address, and discard the new 

address.

Confirm the new setting by typing the command 

.  If Quadra 

has accepted the command, it responds with the new IP address that 
you just entered.

Once you have set the IP address, you can connect your PC to Quadra using 
Ethernet.  In Chapter 2, refer to the “

” section for 

instructions.

. . . . . . . . . 

Quadra’s IP address can be set directly via Ethernet, using a Telnet session that 
enables you to remotely log into a computer.  This procedure is not required if 
you have already set the IP address using the method described above, in the 
“

” section. 

Use the following procedure to set up the IP address with a Telnet session:

Use an Ethernet crossover cable to connect directly between the 
Quadra’s Ethernet port the network port of your PC.

Open a web browser window on your PC.  Internet Explorer

®

 is 

recommended. 

Highlight the default URL (Uniform Resource Locator) in the 
browser’s address line and press 

.

In the browser’s address line, type:

telnet://<ipaddress> 8000

where <ipaddress> represents Quadra’s current IP address. 

S

Example:  If you have not changed Quadra’s default IP address, it 
should be set to:

192.168.1.200

Using the default IP address shown above, in your browser’s address 
line, type:

telnet://192.168.1.200 8000  

... and press 

.

For this procedure, the direct connection method is 
recommended over the network method.  This avoids 
potential conflicts between Quadra’s default IP address 
and your network.