IMC Networks SNMP 用户手册

 

10

 

function enables ALL of the traps.  To selectively activate and deactivate 
traps, use iConfig.  iConfig Traps allow greater control using the Trap Edit 
than the serial and Telnet does. To choose generic or enterprise-specific 
Traps, use iConfig. 

To remove all trap destinations, press K. Press Y to remove all trap 
destinations.  Press N to abort and then press Enter. 

The serial configuration does not have a default password; it is optional. 
Password protect the serial configuration process by pressing P from the 
main configuration screen. Type the password and press Enter. Passwords 
are case sensitive and should be no more than eight characters in length, 
with no spaces. This password will be requested whenever logging on or off. 
To remove password protection, select P and instead of entering a password, 
press Enter.  

To Enable/Disable DHCP, press D and then type reboot for the changes to 
take effect.  Refer to page 5 for more information. 

When ending a session, press E before disconnecting the cable in order to 
stop the device from continuing to send feedback status through to the serial 
port.  If a session is not ended properly, the Telnet session cannot be 
launched. 

With the iMediaChassis series, firmware can be downloaded from a central 
server via a TFTP protocol.  Initiate this download via serial configuration or 
Telnet session.  Make sure the IP Address and the name of the file being 
downloaded are correct in the Current Values section of the Main 
Configuration screen. To download a file, press the Space Bar in the 
Command List section of the Main Configuration screen (serial 
configuration).  Type download and press Enter to be taken to the 
Download a File screen.  This screen displays the IP Address of the TFTP 
server and the name of the file.  Press Enter to start downloading the file.