Intel LH500 用户手册

3.5 Advanced Menu:

PhoenixBIOS Setup Utility

Main Advanced Security Power Boot Exit

Item Specific Help

  Multiprocessor Specification    [1.4]
  Installed O/S:                           [WIN2000]
  Reset Configuration Data:       [NO]
  Large Disk Access Mode:         [DOS]

Parallel ATA:                            [Both]
Serial ATA:                               [Disabled]
  Native Mode Operation:           [Auto]

►Advanced Chipset Control
►Advanced Processor Options
►I/O Device Configuration
►Console Redirection

  Legacy USB Support:            [Enabled]
►IPMI

F1 Help ↑↓ Select Item -/+ Change Values F9 Setup Defaults
ESC Exit ←→Select Menu Enter Select►Sub-Menu F10 Save and Exit

The following table shows the items that you can customize on the Advanced menu page:

Item Options

Description

Multiprocessor Specification

1.1
1.4

Configures the MP specification
revision level. Some operating
systems will require 1.1 for
compatibility reasons.

Installed O/S

Other
Win2000

Select the operating system
installed on your system which
you will use most commonly.
Note: An incorrect setting can
cause some operating systems to
display unexpected behavior.

Reset Configuration Data

No
Yes

Select ‘Yes’ if you want to clear
the extended system
configuration data (ESCD) area.

Large Disk Access Mode

Other
DOS

Unix, Novell NetWare, or other
operating systems, select
‘Other’.
If you are installing new
software and the drive fails,
change this selection and try
again. Different operating
systems require different
representations of drive
geometries.