Motorola MVME712-13 用户手册
General Information
1-2
MVME712-12/-13/A/AM/B Transition Modules and LCP2 Adapter Board UserÕs Manual
1
❏
External Ethernet interface (through the LCP2 adapter) (MVME712B)
❏
Built-in modem (refer to Appendix A) with front panel Telco modular jack
(MVME712-13 and MVME712AM)
(MVME712-13 and MVME712AM)
❏
Electrostatic Discharge (ESD) protection on front panel
❏
Radio Frequency Interference (RFI) protection on front panel
Features of the LCP2 Adapter Board
The features of the LCP2 Adapter Board include:
❏
A 50-pin connector permits SCSI cable connection to other SCSI devices
and/or to the MVME712B through a flat ribbon cable
and/or to the MVME712B through a flat ribbon cable
❏
SCSI terminating resistors mounted in sockets for
end of cable
or
middle of
cable
configuration
❏
Terminator power is developed on the LCP2 adapter from the +5 Vdc on
connector P2 and is fused (1 amp) on the LCP2 adapter
connector P2 and is fused (1 amp) on the LCP2 adapter
❏
A 64-pin connector interfaces the EIA-232D ports and printer port signals
to the MVME712
to the MVME712
x
Specifications
The MVME712 family module specifications are given in Table 1-1.
Table 1-1. MVME712 Family Specifications
Characteristics
SpeciÞcations
Power requirements
+ 5 Vdc, 281 mA maximum (255 mA typical)
+12 Vdc
- 12 Vdc
+12 Vdc
- 12 Vdc
I/O ports
Serial
Four multiprotocol (connected through the
LCP2 adapter)
LCP2 adapter)
Parallel
Parallel printer port (connected through the
LCP2 adapter)
LCP2 adapter)
Operating temperature
0 degrees to 55 degrees C at point of entry of
forced air (approximately 5 CFM)
forced air (approximately 5 CFM)
Storage temperature
- 40 degrees to 85 degrees C
Relative humidity
5% to 90% (non-condensing)
Physical characteristics
(excluding front panel
and MVME712B)
(excluding front panel
and MVME712B)
Height
Depth
Thickness
Depth
Thickness
9.187 inches (233.35 mm)
3.200 inches (80.00 mm)
0.063 inches (1.60 mm)
3.200 inches (80.00 mm)
0.063 inches (1.60 mm)