Motorola MVME712A 用户手册
MVME712A/D3
2-1
2
HARDWARE PREPARATION
AND INSTALLATION
Introduction
This chapter provides unpacking instructions, hardware preparation, and
installation instructions for the MVME712 family modules and the LCP2
adapter.
installation instructions for the MVME712 family modules and the LCP2
adapter.
Unpacking Instructions
N
ote
If the carton is damaged upon receipt, request that carrier's
agent be present during unpacking and inspection of
equipment.
agent be present during unpacking and inspection of
equipment.
Unpack equipment from shipping carton. Refer to packing list and verify that
all items are present. Save packing material for storing and reshipping of
equipment.
all items are present. Save packing material for storing and reshipping of
equipment.
MVME712
x
Module Preparation
To select the desired configuration and ensure proper operation of the
MVME712
MVME712
x
module, certain changes may be made before installation. These
changes are made through jumper arrangements on the headers. The locations
of the headers and connectors for the MVME712
of the headers and connectors for the MVME712
x
are illustrated in
The modules have been factory tested and are shipped with factory-installed
jumper configurations that are shown in the following paragraphs with each
header description. The modules are operational with the factory-installed
jumpers. The modules are configured to provide the system functions
required for a VMEbus system. Changes may be made for the following
reasons:
jumper configurations that are shown in the following paragraphs with each
header description. The modules are operational with the factory-installed
jumpers. The modules are configured to provide the system functions
required for a VMEbus system. Changes may be made for the following
reasons:
❏
DSR Line Pull Up Select (J8, J9, J13, J14)
❏
Serial Port 2/Modem Port 2 Select (J16, J17)
❏
Hardwired as DTE (
to modem
). With the exception of the DSR line, no
headers are provided on the module to change this configuration. To use
the module as DCE (
the module as DCE (
to terminal
), a null modem cable must be attached.