Motorola MPC5200 用户手册

Use the 

KwikNet

 Configuration Manager to edit your Network Parameter File to include

this Ethernet device driver.  Assume that you require the following configuration for use
on the Motorola Lite5200 Evaluation Board.

MPC5200 FEC is to be used operating at 10Mbps.
Caching must be accommodated.
The Ethernet link must operate in half duplex mode.
PHY device wiring mode is 18-wire (MII).
The controller is to be assigned Ethernet address 

.

KwikNet

 IRQ identifier 71 (

) identifies the BestComm Ethernet RX task as the

interrupt source.

KwikNet

 IRQ identifier 41 (

) identifies FEC channel 0 as the interrupt source.

2 transmit buffers and 8 receive buffers are required.

Enter the following five device driver parameters:

Parameter #1:

Parameter #2:

Parameter #3:

Parameter #4:

Parameter #5:

Generate your 

KwikNet

 Library Make File and use it to build your 

KwikNet

 Library.

Compile the 

KwikNet

 board driver module 

.

Create the 

KwikNet

 MPC5200 BestComm Library 

 from the compiled object

modules for the device driver module 

, the pin assignment module

, the BestComm support module 

 and the BestComm API and

microcode source files.  Follow the instructions provided in Chapter 5 of the 

KwikNet

MPC5200 FEC Device Driver User's Guide.

Revise your 

KwikNet

 application link specification to include the board driver object

module 

 along with your application modules.  Link library module

 after the 

KwikNet

 PPC

32

 Library 

 or the 

KwikNet

 Porting Kit

Library 

.